Attached is a 3D of an oil pan intended for use with an RV9-A. I intend
to square up the rounded edges where the sides and bottom meet.
My questions are:
1. How thick should the rear engine mount fittings be on the rear of the
pan? How much reinforcing is needed?
2. How thick should the front lip be where it is supported by the
S-beam? The 3D shows 0.2" which seems to be the thickness of the lip all
the way around. Is this necessary or could we just reinforce the front
and/or rear lips?
Doc Custer
Retired Software Engineer and sometime Audiologist
Latest RX8 engine thinking on the oil pan.
1. back panel is 1/8th thick inch. Bushing holder thickness is .375.
See the attached Barry chart.
2. Keep the .2 thickness (3/16th) dimension all the way around.
It needs to be stiff to avoid oil leaks.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.