Subject: Lastest thinking in RV10 motor mounts.
From: Rotary Engine
Date: 5/14/2007, 8:44 AM
To: AARotary Engine



    This is a two rotor of course but the same ideas apply
    to a 3 rotor. Comments anyone? See any problems?
    --
    Paul Lamar ...No rotor no motor.

Paul,
 Doesn't the snubber/shock absorber require a triangulation for vertical
forces? It seems like any input would bend the small tubes holding the
"ring" at the back. The other thing I'm wondering about is, does the 20B
balance farther rearward? It would seem that it would have to with the
additional weight. That would require a stronger rear engine mount or a
different front mount.
Bill Jepson


That rear beam will easily take the load of a 20B. Don't forget the thrust
counter balances the static weight on the rear beam seeing as how the thrust
line is above the front main bushings. To triangulate that point would require
a bird gage of tubes. I'll upload an analysis of the stresses on the rear beam shortly
based on a download of 6 G's or about 600 pounds.

---------------------------------------
Bill, this is a crude approximation of the stresses assuming a 100 pound static load
on the 3 rotor version with no thrust applied. In other words a hard dead stick landing.
The short cut trick is to ignore the tube moment of inertia and
assume the top and bottom plates, that are separated by 1.5 inches, take all the load. This
yields a conservative crude estimate of the stresses in the top and bottom plates
of the rectangular 4130 .049 wall tube for simple bending. We will probably use
.065 tube.

Looks like about 65K at 6G's well within the capabilities of 4130. .049 thick Straps on the top
and bottom of the joint would add additional insurance.

Not the whole story on a complex bent beam like this of course but it takes FEA to get that.
I just got a  new FEA program which I will apply to the beam as soon as I get around
to it. Should be interesting. If anybody with FEA that would like to do it that
would help out greatly.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.