---------------------------------------
Bill, this is a crude approximation of the stresses assuming a 100 pound
static load
on the 3 rotor version with no thrust applied. In other words a hard
dead stick landing.
The short cut trick is to ignore the tube moment of inertia and
assume the top and bottom plates, that are separated by 1.5 inches, take
all the load. This
yields a conservative crude estimate of the stresses in the top and
bottom plates
of the rectangular 4130 .049 wall tube for simple bending. We will
probably use
.065 tube.
Looks like about 65K at 6G's well within the capabilities of 4130. .049
thick Straps on the top
and bottom of the joint would add additional insurance.
Not the whole story on a complex bent beam like this of course but it
takes FEA to get that.
I just got a new FEA program which I will apply to the beam as soon as I
get around
to it. Should be interesting. If anybody with FEA that would like to do
it that
would help out greatly.
Paul Lamar ...No rotor no motor.
Paul,
I agree that the mount will be able to handle the load. My concern was
to be sure
that the S-beam wouldn't have to handle a large torque load in typical
flight. Turbulence
for instance would put larger loads into a mount that wasn't balanced
around the CG.
I realize that the loads wouldn't be anywhere near the load limits of
the material. My
concern is primarily fatigue. I'm probably being a worry wart on this,
just trying to be
careful.
I am getting a FEA version of Solidworks in a couple of weeks. I'll
require a while to get
up to speed with it.
Bill Jepson
Unless of course you are thinking about the engine torque pulsations.
Our S beam is sized about the same as the O-550 beam in the
Questair Venture it should be OK.
Since all the other stresses are calculated at 6G the stresses at 1 G are 1/6 th
of those so that is well below the fatigue limit of 4130.
You also need over a million cycles for fatigue. That takes a long time in GA.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.