Subject: Cut another p-port today
From: Rotary Engine
Date: 5/18/2007, 8:58 AM
To: AARotary Engine



We cut another P-port today. I was going to try a Starrett 1-7/8" carbide hole saw
to speed up the process but found the hex arbor would not fit in the Bridgeport
mill using a chuck. We had the knee all the way down. It requires a hex 3/8th 5C collet
to fit in the mill above the rotor housing. I'll order one so we can use it the next time.
I am planning on having Mazdatrix building up a p-port RX8 engine to see how much power
it has using the Mazdatrix dyno.

Another alternate way is use a 3/4" shank 1-3/4" drill. Rather expensive at around $80.
That also requires a one inch drill  for the initial hole.

I am going to use this junk rotor housing as a test piece to see if the tig welded 2" SS
intake tube works. We will try to tig weld the tube to the steel trochoid
liner. BTW the steel liner is hardened. We tested it with a file. I was surprised. I
previously thought it was mild steel.

Jim Poole did the machining and he was a bargain at $35 an hour.
If you don't want to do it yourself Jim has done five so far so he is getting
good at it.

This may also be done on a medium size lathe if you lay the rotor housing
on its side on the cross slide and using a boring head in the head stock.

Paul Lamar ...No rotor no motor.

We are getting ready to p-port a junk housing.

I notice that the hole is somewhat off center to the boss cast into the
housing in the direction of the exhaust port. How far should this distance
be?

Doc Custer
Retired Software Engineer and sometime Audiologist

From the bottom of the rotor housing it is 8.64 inches.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.