I did away with the X in the bottom plane and put in
two tubes from the nose landing gear bucket near  the firewall to
the rubber bushing holders.

This will better transfer the inertia loads from the
engine into the nose gear if the nose gear hits a pot hole.
Less likely to damage the firewall area.

Everything you see in green was added. Everything else in
gray is stock RV10 motor mount.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.