Paul,  how long is the center horizontal portion of the rear beam?
Just give me the top edge length.  The bottom will be longer due to
the miters.  Do you have a separate drawing of the rear beam?
Jerry

Here they are. Last one is the just the rear beam.

--  Paul Lamar ...No rotor no motor.

thanks,  BTW,  for my purposes to have the dimensions before the off
sets are applied is more useful and avoids possible errors on my
part.   I set the engine up dead center and straight ahead.  Those
are the measurements I need.   Then I apply the offsets and the
measurements  change accordingly but I don't worry about them at that
point.  They are what they are.   Jerry

OK I will redo the dimensions later today.
I guess all you need are the dimensions of the beam if you do that.  Correct?
Or do you need some others? Tell me what you need.

Paul Lamar ...No rotor no motor.

I think I am O.K.  All I need to start any engine mount is the four
corners on the firewall, the thrust line without offsets and the
distance from firewall to prop flange.  I set this up and then apply
the thrust off sets.  Since the rear beam may change slightly from
mount to mount I will need a drawing of it as well.  We are good to
go.     Thanks,  Jerry


-

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.