I am just about ready to put the engine mount together, so I need Barry
Mounts. I thought I had save an email that specified the size, etc. but
I can't find it. Must have been lost last Jan when the disk crashed.

What is the right size Barry mount for the S-beam? And the rear support
using the elastomer filled rod ends?

Doc Custer
Retired Software Engineer and sometime Audiologist


The front mounts are 22002 design. See the attached chart.
The rear rubber rod ends are the 1/2-20 male. One right hand
and one left hand for simple adjustment down thrust adjustment.


Paul Lamar ...No rotor no motor.

I can't find Barry mounts anywhere on the web. I tried McMaster-Carr first.

Anybody know where I can buy some?

Doc Custer
Retired Software Engineer and sometime Audiologist

Any bearing supply house should be able to order them.
Also contact Barry Controls and ask for a list of "distributors"

McMaster Carr sells them but under a different name.
They are called "Neoprene All-Direction Center-Bolt-Through Mounts"
in McMaster speak.

I would buy a selection of durometers and use the hardest one
one that gives an acceptable  vibration level.
$7.50 each is free compared to a $100 Lycoming mounts :)
http://www.aircraftspruce.com/menus/ep/mounts.html

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.