>> I am just about ready to put the engine mount together, so I need  >> Barry
>> Mounts. I thought I had save an email that specified the size,  >> etc. but
>> I can't find it. Must have been lost last Jan when the disk crashed.>> What is the right size Barry mount for the S-beam? And the rear  >> support
>> using the elastomer filled rod ends?
>> Doc Custer
>> Retired Software Engineer and sometime Audiologist
>> The front mounts are 22002 design. See the attached chart.
>> The rear rubber rod ends are the 1/2-20 male. One right hand
>> and one left hand for simple adjustment down thrust adjustment.
>> Paul Lamar ...No rotor no motor.
>
> I can't find Barry mounts anywhere on the web. I tried McMaster- > Carr first.
>
> Anybody know where I can buy some?
>
> Doc Custer

Doc,  check the info that I included with the S beam.  All that
data including part numbers and sources is there.

Jerry Hey

They are on Mc-Master Carr's online catalog, page 1318.
http://www.mcmaster.com/

Scott Gettings


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.