I am just about ready to put the engine mount together, so I need  Barry
Mounts. I thought I had save an email that specified the size,  etc. but
I can't find it. Must have been lost last Jan when the disk crashed.
What is the right size Barry mount for the S-beam? And the rear  support
using the elastomer filled rod ends?
Doc Custer
Retired Software Engineer and sometime Audiologist
The front mounts are 22002 design. See the attached chart.
The rear rubber rod ends are the 1/2-20 male. One right hand
and one left hand for simple adjustment down thrust adjustment.
Paul Lamar ...No rotor no motor.

I can't find Barry mounts anywhere on the web. I tried McMaster- Carr first.

Anybody know where I can buy some?

Doc Custer

Doc,  check the info that I included with the S beam.  All that
data including part numbers and sources is there.

Jerry Hey

Jerry,
Which one in particular are you recommending, for those of us who suffer the
'Tyranny of Distance" and need a guide to making out own.
George ( down under)

George,  this is the number I have been using:  *22002-12.   * The engineers at Barry suggested this after looking at our application.    Jerry

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.