Subject: Welded P-Port Housing
From: Rotary Engine
Date: 5/27/2007, 8:31 PM
To: AARotary Engine



Paul,

I finally got around to doing the test welding of the p-port insert.  I
used 2" OD 4130 tubing, because that's what I had on hand.  See
the enclosed pictures for results.  The weld was done in a criss-cross
fashion and the housing never got over about 140 degrees (judged by my
being able to handle it with my bare hands).  I checked it afterwards
for shrinkage and could not detect any change.  I figure that there is
such a large mass of aluminum that it acted as a heat sink and shrinkage
wasn't a problem.  In my opinion, the test was a success.  All it needs
now is some JB Weld to seal the water jacket from the outside.

Mark S.

Wow! Good work Mark.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.