Looks like my coolant leak is a self-inflicted wound. Turns out the fitting on
top of the end housing was a coupler that screws into a straight threaded
fitting which is itself bonded into the end housing. The small amount
of jbweld was probably just there to prevent the coupler from unscrewing itself.
In any case, when i removed the coupler I discovered it was cracked all along
its length. Tough to be water / pressure tight when the coupler is cracked
through. Self inflicted because... Yes, you guessed it... I screwed a tapered
thread AN adapter into a straight thread coupler. So, it looks like the
Mazdatrix guys were geniuses after all - they found a way to build the
fitting such that my tendency to put tapered where straight should go
would only break a $1 part.
Mark (Rocky mtn high)
Dang Mark you got me all excited :)
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.