Subject: Mikuni RX8 P-port engine
From: Rotary Engine
Date: 5/28/2007, 8:16 AM
To: AARotary Engine





     > Mikuni HRS48 is looking good. I'll mount the carbs close to the
    engine
     > for good idle and low profile and use a 25 inch long stack.
     > Mikuni claims 120 HP per carb which is perfect for our use.
     > If a Mikuni can live on a hog it can live on a rotary.
     > Paul Lamar

    Hi Paul,
    what inlet tract length are we looking at here?
    BR, Dave McC

    Total length from throchoid surface to trumpet mouth is 25 inches.
    BTW since there are two separate carbs that gives the Mikuni's an
    advantage over the dual throat 58 mm Weber as the Weber throats are
    too close
    together to mount next to the p-ports. In other words the Mikuni's
    ought to idle pretty good becasue the slides are close to the rotor
    housing.

    Paul Lamar ...No rotor no motor.

    Paul,

    Another advnatage of the Mikunis is that they are very icing-resistant.

    In a butterfly valve carb, when the throttle is closed fuel is
    sprayed right at the butterfly valve. The evaporative cooling of the
    fuel turning into vapor is absorbed by the butterfly valve which
    becomes very cold.

    Air full of moisture that comes in contact with that butterfly valve
    condense or sublimates (goes directly from vapor to ice crystals)
    and ice forms in the tiny openings between the butterfly valve and
    the carb throat. Soon the carb is iced over.

    Slide throttle carbs don't have butterflies and the fuel is squirted
    downstream of the throttel opening, so most of the cooling effect
    takes place downstream of the carb where there is nothing to ice over.

    Also you have two carbs, so there is half as much evaporative
    cooling going on in a given carb as with a single carb.

    And finally, if you mount them near the ports like you intend you
    will get some radiation heating from the exhaust manifold just
    below. There is no way you will get any icing with that setup.

    No need to run hot air to the carbs at all.


    Dave,

    That's an interesting idea about using the starter enriching circuit
    for leaning the carb. I don't know how well it works on Webers but I
    don't think it will work too well on the Mikuni.

    It says in the Mikuni manual that the starter enrichment is
    effective only at low throttle opening and loses effectiveness as
    the throttle is opened. Still, it's worth trying to see what happens.


    Regards,

    Gordon.

 Unfortunately FAA inspectors are not that smart. If it
has a carb they want to see carb heat. One could try this
argument however. No harm in that.

Also you want to shield the exhaust from the carb as Tracy has been there
and done that. He boiled fuel in the float bowls in his first, three
32 mm Mikuni carb set up. This is a picture of Finn's airplane but he inherited
Tracy first 3 carb engine.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.