I am considering this combo for my STOL 701. The designer has
limited the 701 to 100 hp but I don't mind having a couple
extra. Fuel will be gravity fed. I will need a lightweight
drive which I am going to start searching for today. It all depends
on whether or not we will be able to purchase aluminum ends and the
shortened eccentric from Richard Sohn when the time comes about a
year from now.
Do you suggest keeping the Mikuni close to the port or is it O.K. to
move it to the other end of the pipe or anywhere in between? With
just one intake there will be room to snake the intake around to any
length we want. I remember the street rods at Seven Stock a few
years ago with the carbs about ten inches from the ports. They idled
good enough for me and seemed to have good throttle response and
made scary power. Jerry
Keep it close to the port for a better idle and use a 25 inch long
velocity stack. In between is the worst scenario.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.