Subject: Leaning a constant depression carb.
From: Rotary Engine
Date: 5/31/2007, 2:05 PM
To: AARotary Engine




Use a needle valve to change the amount of dynamic pressure applied to
the top chamber. Just a small controlled leak would also probably work.
Unfortunately this super simple scheme won't work on the Mikuni 48 mm.
Paul Lamar ...No rotor no motor.  Paul, I like the idea of a simple system, but I don't believe a controlled leak will work.
An incredibly small leak will foul up a vacuum system. The worst part is a tiny tweak to far and the piston falls all the way causing the
engine to stop. Even at high altitude I really don't want that to happen. I
really believe that fuel [level] is the way to go here. Bill Jepson OK here is an illustration of such a system.
Paul Lamar ...No rotor no motor.
Paul,
That looks more like it. A fine thread around the seat body and a
actuation
lever. Much safer for the ham-fisted pilot. (like me!) For a carb
system this
is much more the way to go.
Bill Jepson

I am not totally convinced. With a real tiny needle valve (literally)
I think it can be made much simpler. Usually the intake leaks
that cause big problems are in the manifold itself down stream
from the mass airflow sensor. In a lot of cases it is hard to get
to the float needle valve seat.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.