This was done by Matt who is the race car chassis builder
at Mazdatrix. It had some aluminum removed around the
steel liner where it was welded to the 304 SS .065 wall tube.
As Mark Steitle discovered this is totally unnecessary.
Removing aluminum is difficult to do and labor intensive as compared
to just welding it in.
It took Matt about five minutes to weld this and I paid him $22 bucks.
Welding them in is not completely necessary but it gives another
level of security against coolant leaks.
Sure is quick and easy to do. I am going to do it on
the RX8 P-port engine.
Paul Lamar ...No rotor no motor.
I gather that grinding the weld down so that it won't interfere with the
apex seal going by is also trivial.. Does it need to be ground away
such that the seal never rides over a region where the weld heat has
altered the liner's physical properties? Or is the metallurgy of the
welded material okay? I realize you might not have enough data to
answer that.
After welding to the liner, is it then only necessary to seal the tube
along the outside of the housing? Or are there other interfaces that
also need sealing?
Sorry, but another dumb question: Does this process eliminate the need
to do that pressurized application of JB Weld, or is it still required
for other places on the tube (where the tube exits the housing on the
outside)?
Matt-
First question about the material properties is right. Long time
wear is unknown.
Yes it is only necessary to seal the outer part of the water
jacket around the steel tube. I will still do that in pressurized
stages to insure there are no leaks.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.