> Hello
>
> I am now the owner of this rotary engine that was
made by Yaw
power. It is
> installed in my newly acquired Merlin GT. The
aircraft has
never
been flown
> and
> the engine has 0 hours on it. To make a long story
short I have
limited
> knowledge on rotary and I need all the help I can get.
>
> Thanks
>
> Ron Anderson
>
>
> I added you to the list Ron so ask any question you
wish no
matter
> how dumb you might think it is. There are no dumb
questions
> on here.
>
> BTW Since the Merlin GT is an ultra light I assume
the engine
> you bought from Paul Yaw was a one rotor. Even the
one rotor
> Mazda engine is a bit heavy for this airplane.
> --
> Paul Lamar ...No rotor no motor.
> I agree and I may have to replace it, but it came
mounted in
the
plane so
I think I'm going to try it first. Other Merlins at Blue
yonder
Aviation are
flying with O 200s, I think they are about 200lbs. And
yes it is
a
one rotor
engine and I have no idea how much it weighs, and it is
the same
engine that is
in the picture. Paul paints his engines blue and the red
was a one
of special
request.
1st question (all my questions will be dumb. sorry)
What type of electronic fuel pump would you recommend
and how
much fuel
pressure is required for a one rotor
2. Any special way to plumb the engine to avoid
excessive heat?
3. Any special type of exhaust system needed?
4. what would be normal temps and oil pressure readings?
Thank you for repleying
Ron Anderson
>
1. I like the MSD or Carter rotary vane fuel pumps.
Not Walbro.
2. Yes of course. The rad and oil cooler ducting and
sizes of
rad and
oil cooler must be correct. This adds weight of course.
You will need a rad of about 300 cubic inches and an oil
cooler
around 120 cubic inches. The larger the frontal area the
better.
In other words 20" by 20" by 1" thick is better than 10"
by 10"
by 4"
thick. Get my cooling book from AC Spruce.
3. Exhaust design is not important but use .065" wall
321 SS on
the
first
third or half of the exhaust. Do Not use mild steel.
4. Try to keep the water and oil below 200 F. 220 F
water and
oil is OK
for awhile but not recommended.
--
Paul Lamar ...No rotor no motor.
Somehow I thought it was 300 cu-in for a 13b and that a
single rotor
would be less. Ron's engine is a single.
Regards,
Matt-
600 cubic inch for a 13B minimum. More is better.
Paul Lamar ...No rotor no motor.
Thanks Paul.. I remembered wrong.
I can see why you state it the way you do. 300 cu-in / rotor is a
more
useful metric.
Matt-
Thanks for all the input but I'm afraid Paul is right, the
engine is just too heavy for this type of aircraft. I do appreciate
the wealth
of knowledge that resides at this forum. Unfortunately after
weighing the
engine, I have no other choice but to replace it. If anyone is
interested in
purchasing the engine give me a yell. Thanks again for your help.
Good Luck to all and safe flying
Ron Anderson
Ron, I might be interested just to get the eccentric shaft. Is the
engine a p port? Jerry
Don't forget the counter weights too Jerry.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.