Subject: Another carb possibilty
From: Rotary Engine
Date: 6/2/2007, 6:19 PM
To: AARotary Engine



Build our own dual horizontal slide carb.

What do you guys think of this idea. The questions
is: can it be built in small quantities NC milled out of a large
chunk of aluminum  cheaper than the price
of two large motor cycle carbs at around $900 ?

The float bowls will have to be re designed to make them
less sensitive to aircraft pitch. The needles and jets could be
stock large Mikuni as well as some of the other parts.

Paul Lamar ...No rotor no motor.


Paul, you are driving Doc crazy and broke :)
Buly

Perhaps you and Doc will like this one better.
It entails going back to the round holes in the Teflon.
The ramps are exaggerated to make them easier to see in this
illustration.  The fuel comes in through the spacer in two 1/16 diameter
holes. Look closely you will see them. The edges of the hole in the Teflon
can be rounded in the area of the fuel feed hole to give a small venturi effect.
The instrument panel mounted pressure regulator is used to lean the fuel.

The over all length and cost of the basic slide throttle is reduced. It is the
same round hole slide throttle Mark Supinski has on his airplane with Tracy's
EFI. Mark should get his engine started this weekend.

Also we ran it on the dyno with the round holes. If necessary a wave spring
can be used under the Teflon to help seal the ramp area. It is also possible
to install a small race track shaped small O-ring groove around the ramp area
in the top of the Teflon slide in necessary.

I am hoping some of you people will tell me what you think of this idea.
It should be even cheaper than the PIXAXE and required less computer
expertize.

---------------------------------------------------------

The pressure regulator replaces the float bowl in the previous configuration.
If you prefer a float bowl one can be hogged out of a block of aluminum
and just about ANY OLD carburetor can supply the internal needed parts
such as float, lever and needle valve. If the 25 inch long intake stacks are made
from 2" ID tubing and a taper fitting is used to adapt them to the
current slide throttle 1-7/8 inch ID bore a venturi will be formed
to suck the fuel out of the float bowl.

If flex lines are used to communicate from the bottom of the float
bowl with the injector holes in the Teflon slide the entire float bowl
can be physically slid up and down to change the fuel level and adjust
the mixture for starting and leaning purposes. This is simple stuff and
hardly rocket science. I suspect this could be very cost effective compared
to two carbs. Probably not as cost effective as using the $35 pressure
regulator.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.