So is the next step to make a composite steel/aluminum p port tube. Thread
the two together in the center and tig both ends.
John Gibbons
?????? :) I have no idea what you are talking about John :)
The aluminum runner on the out side of the slide throttle is tig welded to
the aluminum outer plate of the slide throttle as in these jpg's.
The inner steel tube is welded to a steel flange that is then bolted to
the
inner side of the slide throttle. It must be that way or you would never
get the engine apart.
Paul Lamar ...No rotor no motor.
John,
Looks like you are thinking of alternatives to sealing and non- permanent
fixture - which is what I'm thinking of as well.
It would be nice to have something which incorporated an O ring or two which
could be replaced in case of any leakage, down the track.
The welding of the inner tube to the steel liner is the premo way of going
IMHO, but as you can't weld steel to aluminium the outer seal is still an
issue.
I was thinking along the way of an outer aluminium sleeve with flange that
is welded to the outer housing with a couple of O rings to seal the two
components - but there are problems with this idea as well.
I'm still thinking on it!
George( down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.