Subject: Time to quit pumping up dinosaurs
From: Rotary Engine
Date: 6/2/2007, 6:50 PM
To: AARotary Engine


Here it is guys, just what the  world needs.    Just fill the tank
with water and head out.  But first don't forget to pour in the
aluminum and add a bit of gallium.  You have just created a very
efficient hydrogen generator.  It has recently been discovered by
scientists at Purdue University that aluminum in the presence of
gallium reacts with water to release hydrogen.   How efficient is
it?  Well two aluminum atoms will release 3 hydrogen atoms. The
additional result is aluminum oxide which is a byproduct that can be
changed back into aluminum when subjected to electrical current.
This too is covered by current technology.  The electricity used for
this process can come from wind and solar sources.  Thus creating a
totally renewable, absolutely GREEN source of power for our beloved
internal combustion engines.

Jerry


Jerry,
Do you have a source of information, one might access?
George ( down under)


"When gallium is alloyed with aluminum it can be used to break the bond
between
hydrogen and oxygen in water. A reaction occurs when water is added to the
alloy
which produces hydrogen and aluminum oxide. This could potentially provide
a
solid hydrogen source for transportation purposes, which would be more
convenient than a pressurized hydrogen tank.[3] Resmelting the resultant
aluminum oxide and gallium mixture to metallic aluminum and gallium and
reforming these into electrodes would constitute most of the energy input
into
the system, while electricity produced by a hydrogen fuel cell could
constitute
an energy output.[4]The thermodynamic efficiency of the aluminum smelting
process is said to be approximately 50 percent. Therefore, at most no more
than
half the energy that goes into smelting aluminum could be recovered by a
fuel
cell."

Doesn't sound like you'll be putting gallium in your tank any time soon.

Jack Hilditch

-----------------------
It is worse than that -- you have to transport aluminum/gallium around the
country, can't do it with pipelines. Energy conversion efficiency (net) will
be very low.

Bill Schertz


Jerry,


There are many possible elements you can do this with.  Magnesium plates
dipped into seawater and wired in series makes for a easy to make power
source.  It is also the reason I worry about magnesium engine parts used on
planes landing in the ocean.

A more practical chemical to use is sodium.  'Na' placed in water in the
absence of oxygen (very important) will give off hydrogen and convert the
remainder to NaOH.  Caustic soda or NaOH is the 11th most produced chemical
in USA and is used in almost every factory process from soap, cosmetic to
steel cleaning, etc.  It takes electricity to recover Na from seawater any
way but the logistics of transporting NAOH H20 solution no matter how
valuable takes a large change in the market infrastructure.

Lithium is better to use and gives up more Hydrogen but Li is a rare
material and China controls 98% of the market. Most of it is going into high
performance batteries.

Here is a car that never seems to be finalized in design but may have some
promise

http://www.theaircar.com/car.html

Doug Fir


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.