Subject: Lowest cost Mechanical fuel injection ever concieved.
From: Rotary Engine
Date: 6/3/2007, 10:49 PM
To: AARotary Engine

This Teflon slide is interchangeable  with Doc's
All you need do is mill a couple of ramps .0625" inch wide
two inches long and drill a couple of small holes.
The down hole can be .0625" diameter.
The ramp depth on the down hole end is .0625"
One of those $8.95 surplus low pressure regulators that Karribian
discovered will serve as the fuel flow control.

I figure you should start with an .025" diameter injector hole.
My guess is about 5 psi on the fuel pressure would be about right
You can always raise or lower the pressure to get the flow just right.

Makes sure you turn the engine over with the starter before you
turn on the electric fuel pump on or the engine will flood.

I'll test this system on the dyno if Karribian does not beat me to it.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.