This was done by Matt who is the race car chassis builder
at Mazdatrix. It had some aluminum removed around the
steel liner where it was welded to the 304 SS .065 wall tube.
As Mark Steitle discovered this is totally unnecessary.
Removing aluminum is difficult to do and labor intensive as compared
to just welding it in.
It took Matt about five minutes to weld this and I paid him $22 bucks.
Welding them in is not completely necessary but it gives another
level of security against coolant leaks.
Sure is quick and easy to do. I am going to do it on
the RX8 P-port engine.
Paul Lamar ...No rotor no motor.
Paul,
How do you get the trochoid surface back to a smooth and bump-free contour?
Bill
Use a dia grinder with sand paper spiral rolls. They are cheap and
work great. Start with course and finish with fine for a glass smooth
surface. Here is the Mc Master page. Don't worry if you grind
through the weld. The JB Weld will take care of the tiny leak.
These things will make an expert out of anybody on porting.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.