I think we need a bit of clarification here.
Changing the fuel pressure in a low pressure injection system
is the same as leaning a carb by changing the pressure in the float bowl.
The simple pressure regulator flows more fuel when the pressure on
the outlet side is reduced. The pressure on the outlet side is reduced
as the air volume flowing through the intake tubes past the slide is increased.
The regulator tries to maintain a constant pressure on the outlet side relative to
atmospheric pressure so if if fuel is sucked out of the outlet
side the pressure in the outlet tube is reduced causing the regulator
to flow more fuel in an attempt to keep the pressure constant.
In effect this is no different than a carburetor.
The advantage is we have done away with the float bowl and replaced
it with a pressure regulator the pilot can diddle the pressure setting.
Clear as mud. Right? :)
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.