Subject: Lowest cost Mechanical fuel injection ever concieved.
From: Rotary Engine
Date: 6/4/2007, 7:13 AM
To: AARotary Engine


   This Teflon slide is interchangeable with Doc's Teflon slide.
   All you need do is mill a couple of ramps .0625" inch wide
   two inches long and drill a couple of small holes.
   The down hole can be .0625" diameter.
   The ramp depth on the down hole end is .0625"
   One of those $8.95 surplus low pressure regulators that Karribian
   discovered will serve as the fuel flow control.

   I figure you should start with an .025" diameter injector hole.
   My guess is about 5 psi on the fuel pressure would be about right
   You can always raise or lower the pressure to get the flow just right.

   Makes sure you turn the engine over with the starter before you
   turn on the electric fuel pump on or the engine will flood.

   I'll test this system on the dyno if Karribian does not beat me to it.

   ------------------------------------------------
   If these air pressure regulators don't work out here is a pretty cheap
   fuel pressure regulator from Holley. $26.95 from Summit Racing.
   You will have to make knob as you don't want to fool around
   with an allen key. The pressure range is 4.5 psi to 9 psi.
   They also make them in the 1 psi to 4 psi range. Same price.

   If you want to go high buck this Mallory regulator
   is $76.88 and has a pressure range of 4 to 12 psi.

   There are others up to $150.

   Paul Lamar ...No rotor no motor.

   Paul,

   I have to wonder about fuel atomization -- or lack thereof -- with
   that one big dribble jet.

   Carbs premix air right inside the jet which helps to get the
   atomization going. Some mechanical fuel injectors do this too.

   And as you know, most carbs have three separate circuits for low,
   mid and upper rev ranges. That's because trying to get one jet to
   cover the whole range does not work well. In a carb, all three are
   flowing at high rpm, which also aids atomization.

   For example how are you going to enrich for starting? You will
   probably have to add some kind of primer.


   Regards,

   Gordon.

The rotary in particular does not give a hoot for exact mixture. It will run
from 10 to one to 18 to 1. That is why all carburetors are over kill for our purposes.
Read the messages Gordon. I already said I would turn up the pressure for
starting. You keep bringing up subjects that have already been addressed.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.