Matt,
I have a better solution, however similar to your, I came up with it last
night.
Use Paul's method to weld in the piece of SS to the liner.
Weld in an aluminum insert the other side which fits neatly over the steel
tube.
The flange can screw to the insert (which has pre drilled and tapped
holes)
the flange which screws to the aluminum inset has a recess to take the
steel tube and an O ring to clamp against the welded insert.
If you then want to seal the cavity you still can, but any future leaks
will
be around the O ring which can be replaced.
Now that's an elegant solution - even if I do say so myself.
George (down under)
All this stuff requires machine tools. At least a lathe while
JB Weld works with just hand tools. I am trying to make this cheap
and easy to do.
--
Paul Lamar ...No rotor no motor.
Agreed Paul, but for those with a lathe and access to TIG welding it's the
way to go.
It was just an exercise in throwing ideas around - we can't expect you to do
all the work, all of the time.
George ( down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.