Subject: What happens if your intake runners are too short.
From: Rotary Engine
Date: 6/4/2007, 5:00 PM
To: AARotary Engine

Here is a dyno curve for a 12A p-port with runners that are too
short. Note the torque peak never reaches a distinctive peak.
Even at 8800 RPM. Consequently the torque and HP are not
as high as it could be with somewhat longer runners.
The 12 A torque should be 12/13 times 200 or 185 foot pounds.
This one is lucky to see 166 foot pounds.

The HP should be more like 276 or more with the right length runners
rather than only 266 HP. Shorter carburetor stacks should be used with longer
runners to enhance the organ pipe effect.
Better yet the carb butterflies done away with and a slide throttle used.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.