Subject: Ellison style dual slide throttle LPFI
From: Rotary Engine
Date: 6/5/2007, 1:22 PM
To: AARotary Engine



This design steals ideas from Ellison and Mikuni. The fuel metering is done with a bunch of small holes drilled into a brass tube that stays in the air passage all the time similar to the Ellison. The slide is three piece similar to the Mikuni 48 mm. As the slide opens it exposes more and more small holes in the brass tube increasing the fuel flow. The brass tube is attached to a stationary rectangular column that is fixed to the spacer. The fuel comes in through the spacer and down the column to the brass tube. The brass tubes fit in holes in the center parts of the slides. The fuel is sucked out of the side of the tube by the Coanda effect. Ellison claims excellent atomization.
The trade off is a more complicated slide. However it is much lower technical risk than the ramp in the Teflon
idea as it uses a tried and true method of metering fuel. There are hundreds
of Ellisons out there on all sorts of airplanes. It does not use the
Ellison method of leaning the mixture. The mixture is still leaned with the external fuel pressure regulator. The Ellison of course has a built in fixed fuel pressure regulator.
It is a bit hard to tell what is going on here by looking at these 3Ds. One has a solid slides and the other transparent slides. Both are
shown in all three positions. Closed, half open and fully open from top to bottom.
This is my fall back option if the ramp in the slide idea does not
work.
Why not use a couple of Ellisons? That will work if you don't mind paying $825 each.
For a lot more on how the Ellison works check out the web site: http://www.ellison-fluid-systems.com/
-------------------------------------------------------------------------
-- 
Here is a blatant dual copy of the Ellison. Nobody will be able to
build it and sell it as Ellison has a good patent on it I am sure. That will not stop an individual from building one for himself. The 1/8 dia. brass tube runs all the way through the 3/8 thick one
piece Teflon slide. It is not easy to machine so be aware.
BTW I gave up on this multiple hole idea because one could not insure the mixture would not vary between holes. Here is what Ben
Ellison has to say on the subject.
"The TBI uses a tube with many holes to meter fuel in the venturi. This
tube is covered by a slide valve used for the throttle. At low power settings,
which are common in auto applications but not in aircraft, the fuel metering
steps from slightly lean to slightly rich as the throttle is opened. This
variation in mixture results in poor fuel economy as well as illegal levels of
exhaust emissions. Aircraft, on the other hand are always above 50% power and
the digital nature of the fuel metering is irrelevant."
So he changed my mind :)
Paul Lamar ...No rotor no motor.

Paul, I doubt that Ellison has a patent on the multi-hole spray bar
because it has been used on several carberators in the past.
Nothing new there. The pressure regulator is more likely to
be the source of any patents. Of course they might not have
been the first, simply the first to patent. Like the Selden patent
on the automobile! The other thing about aircraft is they are
usually under carberated. They tend to have high vacuum levels
as the carb is the greatest restriction on the system. Makes
things easier.
Bill Jepson
Here is a chart showing intake manifold pressures.
Looks like the Ellison gets along with less MAP.

-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.