Here is a blatant dual copy of the Ellison. Nobody will be able to build
it
and sell it as Ellison has a good patent on it I am sure. That will not
stop an individual from building one for himself.
The 1/8 dia. brass tube runs all the way through the 3/8 thick one piece
Teflon slide. It is not easy to machine so be aware.
BTW I gave up on this multiple hole idea because one could not
insure the mixture would not vary between holes. Here is what Ben Ellison
has to say on the subject.
"The TBI uses a tube with many holes to meter fuel in the venturi. This
tube is
covered by a slide valve used for the throttle. At low power settings,
which
are common in auto applications but not in aircraft, the fuel metering
steps
from slightly lean to slightly rich as the throttle is opened. This
variation
in mixture results in poor fuel economy as well as illegal levels of
exhaust
emissions. Aircraft, on the other hand are always above 50% power and the
digital nature of the fuel metering is irrelevant."
So he changed my mind :)
Paul Lamar ...No rotor no motor.
Paul,
Wouldn't you need something to block-off the fuel metering holes as you move
the slide to close (reduce power).
Is there something I'm not seeing here?
George ( down under)
The brass tube is fixed to the body of the slide throttle so as
you close the Teflon slide it moves over the tiny holes closing more
and more of them off. The hole in the slide is just .001 larger
than the brass tube.
The Ellison works the same way. The tube is fixed to the body and
the slide opens and closes the tiny holes.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.