Subject: Ellison style dual slide throttle LPFI
From: Rotary Engine
Date: 6/6/2007, 7:51 AM
To: AARotary Engine



Unnecessary. the tube is fixed at one end to the housings.
I am working on some improvements to make it easier to make.
It also will work better with Doc's slide throttle as it is.
-----------------------------------------------------------

Here are some better illustrations. Feed the fuel from the left
end of the brass tube. The holes in the tube where it is used to
feed the second rotor will be slightly larger
to equalize the fuel flow to each rotor. The brass tube can
be twisted 90 degrees to lean exactly the same way Ellison
is doing it.

We still have an external adjustable regulator to
control the over all flow and provide extra fuel for starting.
That is the only way this system deviates from the way Ellison
does it.

Paul Lamar ...No rotor no motor.

Paul,
I'm with you now the drawing threw me a little I understand the uncovered
part of the tube ( as the port closes) doesn't have holes in that section,
good- oh!

If there was to some variation in the holes I suspect it would only be
spacing between the holes rather than the hole sizes being changed e.g, idle
might have more holes per" with mid range being more widely spaced and again
more holes per inch at WOT.
George ( down under)

Yes you could change tubes like you change needles now in most slide carbs.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.