Subject: Ellison type tube capture and dimensions on the slide throttle.
From: Rotary Engine
Date: 6/6/2007, 10:26 PM
To: AARotary Engine



Ellison type tube capture and dimensions on the slide throttle.

The slots are for two fuel sealing O-rings and a snap ring.
The gold part is made from brass and soldered to the end of the tube.
The gold square part is to clamp a leaning lever (not shown yet) on it so
the tube can be rotated by a mixture control. Fuel is fed into the
end with a swivel fitting. there are other ways of doing it.

So if you come up with a better way please include a scale drawn sketch.

The blue retention clip goes around the outside end of the slide throttle.

Paul Lamar ...No rotor no motor.

Paul,
Why not cut a groove in the brass tube, centered between the slide openings
and feed the fuel through the slide. Should help equalize the fuel flow
between the rotors.

John Gibbons

That is a good idea. I'll take a look and see if it will fit
in.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.