Ellison type tube capture and dimensions on the slide throttle.
The slots are for two fuel sealing O-rings and a snap ring.
The gold part is made from brass and soldered to the end of the tube.
The gold square part is to clamp a leaning lever (not shown yet) on it so
the tube can be rotated by a mixture control. Fuel is fed into the
end with a swivel fitting. there are other ways of doing it.
So if you come up with a better way please include a scale drawn sketch.
The blue retention clip goes around the outside end of the slide throttle.
-----------------------------------------------
Here is what it looks like with the leaning lever and assembled.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.