Subject: Ellison type tube capture and dimensions on the slide throttle.
From: Rotary Engine
Date: 6/7/2007, 10:25 PM
To: AARotary Engine



Ellison type tube capture and dimensions on the slide throttle.

The slots are for two fuel sealing O-rings and a snap ring.
The gold part is made from brass and soldered to the end of the tube.
The gold square part is to clamp a leaning lever (not shown yet) on it so
the tube can be rotated by a mixture control. Fuel is fed into the
end with a swivel fitting. there are other ways of doing it.

So if you come up with a better way please include a scale drawn sketch.

The blue retention clip goes around the outside end of the slide throttle.

-----------------------------------------------

Here is what it looks like with the leaning lever and assembled.

------------------------------------------------------------

I figured out how to get rid of one part and a swivel fuel
fitting. Here is the 3D. The tube is shown in the full rich position.
As the tube is rotated towards the full lean or idle cut off this
down tube and the fitting form a barrel valve that shuts off the
fuel flow in addition to the dynamic pressure flowing into the
tiny fuel feed holes.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.