Subject: Resurfaced rotor housings on Ebay
From: Rotary Engine
Date: 6/7/2007, 3:56 PM
To: AARotary Engine


    >>  I ran across this item 110135230181. Rotor housings
    >> are stripped of chrome and resurfaced with cermet.
    >>
    >> Robert LeClercq
    >>
    >>
    >> I would be extremely skeptical. Mazda spent millions on figuring
    >> out what works. Try ANYTHING else out at your own extreme risk.
    >> That includes after market apex seals.
    >>
    >> --
    >> Paul Lamar ...No rotor no motor.
    >
    > Paul,
    > They claim that the LeMans race car used this technology - sounds
   like
    > someone who has access to this site has started this business.
    > George ( down under)

    > It is not only what they put on it but HOW they put it on. The
   only thing
    > that has a snow balls chance in .... of working is detonation gun
    > coating.
    > Detonation gun coating is extremely expensive and than must be
   diamond
    > ground. It is probably way cheaper to buy a new rotor housing.
    >
    > BTW I have seen rotor housings from engines that have had a ceramic
    > coating applied
    > on the rotor. The coating came off the rotor and the rotor housings
    > surface looks
    > like it was sand blasted.
    >
    > Paul Lamar ...No rotor no motor.

   If you are seriously considering these housings you should read some of
   the threads
   at rx7club.com <http://rx7club.com>
   JHB had a lot of startup/delivery/process control problems and not a lot
   of published
   testing or long term wear results.  I have heard of at least one
   instance where large sections
   of the coating sloughed off in sheets.  I hold out hope they are are
   successful.

   Also, there are several threads regarding TES oring problems over at
   nopistons.com <http://nopistons.com>.

   Cheers
   Cary




What about using keronite on the aluminum housings?

http://www.keronite.com/

Paul Chang

I am not against any individual doing anything for himself as long as he understands
the risk and is not selling it to others that may be unsuspecting victims.

Mazda has built two million engines with chrome on hard steel liners.
The same process is used on millions of aircraft engines.
Any competing process would have to under go thousands hours of use with
many different engines to provide a similar warm feeling.

The problem is the underlying aluminum has 1/3 the modulus of elasticity
of steel. It there fore flexes more under point contact loads. Therein lies
the adhesion problem regardless of the type or method of coating.

The Mazda  hard steel liner on the other hand is mechanical locked to the
aluminum housing using thousands of "teeth".

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.