We have balanced them before.

Assuming the shaft is made retaining the rear rotor journal, the keyway
groove in the rear counterweight needs to be re-cut 180 degrees out to put
BOTH counterweights on the same side, then a bunch of weight is taken out of
both of them.

Mazdatrix Inc.
2730 Gundry Ave.
Signal Hill, Ca. 90755
Phone: 562-426-7960
Fax: 562-426-9646
www.mazdatrix.com

Not a bad guess off the top of the head, but WRONG.

It's the front keyway that needs to be cut 180 degrees, if your retaining
the rear journal. It's it your taking the front journal and turning it 180
degrees and superimposing it on the rear journal.

Both  counterweights need to be on the opposite side of the eccentric lobe.
Richard's right again - as there's no rocking couple a static balance will
get you in the ball park. Can't say how close it will be though.
George (down under)


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.