Subject: Ellison type tube hole patterns and sizes
From: Rotary Engine
Date: 6/9/2007, 4:24 AM
To: AARotary Engine

I calculated the air opening area of the slide in .2 inch travel increments.
I then attempted to match the fuel flow to the slide opening area.
Roughly speaking it takes 27 .013" dia. holes variably spaced
along the tube. Each hole passes enough fuel for 4.45 HP at 2 psi so
27 holes is 120 HP per runner. 240 HP for the p-port engine.

As Ben Ellison says this causes a stepped ramp digital supply of fuel.
In other words the engine goes from rich to lean and back to rich as the
slide moves. The problem is severe in the first one third
travel of the slide throttle. Ellison largely got around this by using much
smaller holes and many more of them. My guess by looking at them is they can be
as small as .1 mm or around 6 thousands of an inch. He probably has
close to 100 holes in his tubes.

BTW I can't for the life of me figure out how they can make a drill that
small but they do. Airgas sells them for $45 each.

More, much smaller holes, soon becomes a problem in a single row as the holes
get too close together. Two or more staggered rows are used in the Ellison.
The first 3rd are a single row. The next third  is a staggered double row and the last
third is a staggered triple row. None of this is shown on any Ellison websites.
Of course this further increases the cost.

I talked to a friend of mine that owns an NC shop here in Santa Paula that
has experience drilling small holes. He says there must be a close fitting
brass rod in the  brass tube or drill breakage occurs frequently. At $45 a crack
you don't want this to happen. Then you have the problem of pressing the
sacrificial brass rod out of the nine inch long 1/8 inch diameter tube. Not
an easy thing to do. That too requires special tooling that supports the outside
of the tube. Perhaps this can be done better with a laser.

I can see why Ellison is charging $850 for his aircraft carbs. It is also rapidly
talking me out of this approach. Not a show stopper yet however as I have
yet to investigate the laser option.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.