Subject: 4 rotor dyno data from Japan
From: Rotary Engine
Date: 6/11/2007, 7:50 AM
To: AARotary Engine

 4 rotor dyno data from Japan

Doug sent me this 4 rotor p-port data. Thanks Doug.
Who was the engineer that gave you this and how
is he related to Mazda Corp.?
-- 
Paul Lamar ...No rotor no motor.



Paul,

The data was given to me by Hisanori Nakane ex head engineer of rotary fuel
efficiency team.  He has his own company now in Hiroshima designing and
making fuel efficient engines. He recently designed a small one rotor rotary
for an European firm. Hisanori has the Guiness world record on the amount of
kilometers driven on a liter of gasoline.

His consultant engineer, in his mid sixties, the name escapes me at the
moment, actually recorded the data.  This man Hisanori later told me has
more engine tuning ability in his head than any dyno machine I am likely to
build.  He was the person who headed the team who designed the intake
manifold for the winning Lemans engine.

There is a lot of information on this data sheet.

The title should read Reproduced Rotary Output Performance Data and Output
Performance at Fixed ROM. I still don't know what to make of the top curves.
Whats ROM stand for?

The lower numbers are obviously the pressure or Pe in Kg/cm2.  The other
numbers from 46.0 to 54.5 I believe are manifold ID.  2 inches is 50.8 ID.
There are several sets of data plotted for comparative purposes. I've
translated them as fixed, previous data and requested data which might be
thought of as desired performance data.

Anyone know what IG=T/L  24/24*  or IG=T/L 20/20* means?


Down below Hisanori drew a line and said the rotary engine tuned correctly
should be able to achieve this BSFC.

Cheers

Doug Fir

I think the Lemans engine had an EFI system  so ROM could be the chip
that holds the mixture look up table. In computerese ROM stand for
Read Only Memory. It is also loosely applied to an EPROM or Electrically
Programmable Read Only Memory. When doing engine development about that
time period it is likely to be an EPROM. Perhaps you can ask him for the mixture look
up table :) If he does not have the mixture look up table perhaps he will
part with a chip. I have a device that will read it. In exchange we can send
him the mixture table data in case he lost the printed stuff.

Burns stainless now has 2-1/8" OD 180 degree 6061 bends at the same 3" center
line radius so I plan to use those on the RX8 P-port engine.

BTW Please print out this 3 page pdf file and mail it to him.
Please ask him what he thinks about it if he does not mind.
Does he speak English? If so perhaps I could contact him directly
if you send me his mail address.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.