Subject: Ellison type tube hole patterns and sizes
From: Rotary Engine
Date: 6/13/2007, 11:20 PM
To: AARotary Engine


   I was going to vary the depth of the slot as the feed hole in the
   spacer is
   a limited diameter. The feed hole dia. is .0625 so the Teflon slot
   width is also .0625. Now if you can get a mill smaller than
   that we could vary both the width and the depth.
   A thin slitting saw could also be used to cut the slot.

   One drawback to laser punched holes is they leave a bit of flash
   around the edges. If you have one tube inside another that might
   be a problem. Also, as Bill Jepson pointed out, the hole sides are
   tapered.
   In a wall of .020" thick the inner hole dia could be .008 but the
   outside
   diameter of the same hole would be .014. Not a good thing I suspect.

   The mass air flow sensor had two heated wires in a bridge circuit I
   think.
   The obstruction is considerable but then again the cross sectional area
   is over kill.

   Paul Lamar ...No rotor no motor.

Paul and Matt,
If using the Ellison type tube holes, control the mixture by having
fewer holes near the opening (idle) side. The Lectron needle is a
variant on the tapered slot idea. You would need smaller openings since
you are using pressure rather than vacuum to deliver the fuel. In my job

I supply machine shops with prints to be built and have used most of the
modern techniques for metal cutting. Laser cutting is more like plasma
cutting, and doesn't leave a totally straight edge. While I think the
low pressure FI has many drawbacks, once working it should be fairly
reliable. Similar to the Elliason. The construction details are more
difficult than you think, sorry to say. It's like a statement I saw in
_Automobile Quarterly_  They were talking about finding a Dusenberg but
the principle is the same. "It will be great when you come up with the
unusual idea that makes this design work. I say unusual because most of
the easer or simpler ideas have been pretty well looked for already! "
(paraphrase)

One other technique you could try Paul. Since you were thinking a brass
tube you could use a very thin slitting saw and cut a series of very
thin slots. Deburring remains the toughest problem. For very small holes
EDM starts to become a practical means to punch holes since the
resultant hole is near perfect and has nil burring. A company I worked
for 20+ years ago made it's fortune providing super fine pipettes to the
semiconductor industry. The body was Tungsten and the holes
were.005-.010 diameter! Matt's idea of counter rotating tubes has
already been done for fluid delivery, and is similar to the means used
to control the stroke of old pure mechanical diesel injector pumps.
Enjoy the research.
Bill Jepson



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.