Subject: Manual to Auto conversion parts question
From: Rotary Engine
Date: 6/13/2007, 7:17 AM
To: AARotary Engine



 > I did a conversion of the first page for you.
 >
 > Though it might help if you are not seeing it.
 >
 > Regards David
 >
 > I did not see that one the first go around.
 >
 > Paul Lamar ...No rotor no motor.
 >
-------------------------
So based on the jpg below which parts are needed, t convert a
manual engine to an automatic, I'm double checking myself,
I'm trying to ensure that I don't miss any bits, please
assume that a "rotary aviation RD-1C" going to be fitted.

Thanks David.

I am not totally sure but as a minimum you will need the AT counter
weight not shown in this dwg (shown in the other dwg you sent) and the
flex plate. However if you have Tracy's gear box the RX8 flex plate
does not appear to work for two reasons. One, the starter is in a different
radial (RX8 flex plate is larger in dia.) position and Tracy's torsional
damper does not bolt up to the RX8 flex plate rumor has it.
Therefore in addition you will need a 2nd gen flex plate apparently but you
need to check with Tracy for sure.

I included your other scanned  dwg.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.