Subject: Manual to Auto conversion parts question
From: Rotary Engine
Date: 6/13/2007, 7:32 AM
To: AARotary Engine


I did a conversion of the first page for you.

Though it might help if you are not seeing it.

Regards David

I did not see that one the first go around.

Paul Lamar ...No rotor no motor.


Paul,


I started working on the engine again today and found some less than
desirable attributes with the old semi-auto
bell housing I have.  Mainly interference with the starter motor.

Do you know if the RX-8 housing will mate up with the and 2nd gen 13B
engine.  Having the starter come in from the rear will give me a lot more
room to fit an CVT inside for the turbo-compound.

Any pictures, or diagrams would be appreciated.

Thanks

Doug

Yes I think it will. As I recall the RX8 housing has one additional
bolt but that should not be a show stopper.

Paul Lamar ...No rotor no motor.

Paul,


Hey that Bell housing looks robust, and spacious as well. I estimate the
length to be about 10 to 11 inches.  Are the bell housing and starter motor
showing up in junk yards yet?

Thanks


Doug

I don't know. I just bought an RX8 auto tranny engine from a junk yard in
Northern California so perhaps he still has the tranny.
Dave Lemon did the deal for me so he knows the name of the junkyard.
I will forward this to him.

Dave what is the name and phone number of that junkyard?
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.