Paul
Since the torque reversal absorber plate will be forward and outside the
bell housing at the connection with the sun gear Bell 47 PSRU input plate,
I
don't really need a flex plate although it is probably lighter then the
fly
wheel starter gear type.
Simple question. Are the RX-8 auto and manual bell housings identical in
design?
You should know that the aluminum racing starter ring gear you witnessed
me
receiving from my racing buddy is smaller in diameter than the standard
13B
2nd gen starter gear diameter. To bad. It was lightweight. Perhaps it
might
fit the Renesis engine.
Doug
I don't think so. But I don't have a picture of the manual version.
--
Paul Lamar ...No rotor no motor.
Doug,
All the lightened flywheels have their sizes tare taken off the manual
flywheel. I assume because the lightened flywheels are used in performance
vehicles with manual gearboxes. Remembering lightened flywheels are NOT
turned down cast manual flwheels but turned steel flywheels to preset
weights. Many can be purchased off the shelf ( or ordered) for many
different model engines.
All manual flywheels are smaller than the Auto flex-plates.
I believe all manual flywheels are the same diameter 298mm OD and all
flex-plates are the same diameter 320mm OD.
I can't for the life of me wonder why the RX8 would be different - but I
haven't checked. Perhaps someone is confusing the manual and flex-plate OD.
I believe the Ross PSRU's used the manual diameter for their lightened
flywheels. This also tends to provide more room in an auto bellhousing.
Their wouldn't be a problem making a lightened flywheel in either aluminium
or steel in either diameter - as Richard Sohn has done with the single. It
would require the engine to be balanced OR make it the same weight as the
combined flex-plate and counter weight. Understanding the weight must be in
the correct place. Richard achieved this with lightening holes, however this
is an assumption on my part. As flex-plates become more scarce, perhaps this
will be only course available to new builders.
I think a flat plate would be easier to mount Tracy's type dampers but would
recess the starter ring more toward the engine, requiring a starter with a
longer snout- probably not too big a deal as their are other ways around
this as well.
Hope that helps !
George ( down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.