Subject: Toughened apex seals
From: Rotary Engine
Date: 6/13/2007, 6:47 AM
To: AARotary Engine


Doug in Japan,
Are you in contact with the gentleman Tomoo Tadokoro in this picture
on the lower right. I would like to bounce some apex seal
ideas off him.

Mostly a metal composite apex seal with high strength steel
1mm dia. round bars or 1mm dia. cable embedded or cast into the special
cast iron 2mm thick body.

His company Micro Techno appears to be in Hiroshima so perhaps the phone
book would work.

The goal is to add toughness, or, if the seal does crack, retain
the cast iron pieces inside the rotor housing slot so they cannot scratch
the chrome wear surface.

The scanned excerpt is from Jack K. Yamaguchi's book "RX8" edited by  John Dinkel
(on this list). ISBN 947659-02-5 P5000E

John, perhaps you have a contact phone number or address.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.