The RX8 flex plate was one inch bigger in diameter. Karibian
Thanks Karibian,
That would make it 320 + 25.4 or 345.4mm.
The bolt pattern is 182mm Radius and 180mmRadius for the one bolt hole.
Lets see that makes it 360 to 364mm Diameter, that would leave 9.3mm or 7.3
between the flywheel and the bolt pattern, The bolts are 10mm.
There is usually about 5mm clearance between a flywheel and inner
Bellhousing wall, then there would have to be at least 7mm of aluminium to
the bolt hole.
Lets see, that makes 5mm clearance 7mm wall thickness and 5mm ( half bolt) =
17mm x2 = 34 + 345.4 = 379.4 - does not add up
I think what must be concluded is that the flex plate is bigger than the
auto RX 8 manual, which is the same for all models.
George (down under)
-
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.