Subject: Looking for an SAE paper (if it exists)
From: Rotary Engine
Date: 6/18/2007, 11:52 AM
To: AARotary Engine



If all this info could be more refined and made available to everyone, I'm
sure it would help.
Hope my input helps.
George (down under)


Here is a dwg in english with an Al Gietzen type starter location.

Paul Lamar

Here is the bolt pattern I have measured from the rotor housing. I do not know how it could hold up against a original Mazda drwg, but I made my side housings using these numbers, and it worked, including the dowel positions.
I did the drilling on the CC(Cheap Chinese) using the DRO.

Richard Sohn
N2071U



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.