Subject: Mazda fuel low level warning probe
From: Rotary Engine
Date: 6/19/2007, 9:15 AM
To: AARotary Engine



Gents,

I'm using a stock Mazda fuel pump and assembly in my feeder tank. A fuel
low level warning probe is part of the assembly holding the fuel pump.
It's normally extended down to the bottom of the car's fuel tank. I've
bent it up to give me an indication when the feeder tank is NOT full.
The probe has one wire that comes out of it to the top plate of the
assembly. I put my multimeter on the wire and on a ground (since I
didn't know where else to put it and selected OHMs on various scales. I
dipped the probe in and out of a can full of gas without any indications
on the multimeter. If the probe is a switch, doesn't it need two
wires? What makes this probe work?

Thanks,
Sandy McNabb
Glass Goose with Rotor

Good question. I have never ever seen one. If it is anything like
the low oil level sensor it is a reed switch with a magnet float.
http://en.wikipedia.org/wiki/Reed_switch
One wire is grounded to the chassis.

Sometimes the level sensors are pots on the end of a float arm.
That will require two wires.

Take some pictures.

Here is the aircraft way of doing it.

Paul Lamar ...No rotor no motor.


If you are looking for a sensor that will indicate when your feeder tank
is not full, you might want to consider the product shown at this web
page:  http://www.aircraftextras.com/LowOilSensor.htm

Although it is promoted as a low oil level sensor, it works equally well
in fuel or water. The optional blinking LED setup is needed to have a
panel warning system that comes on when the fluid level drops below the
top of the float.

Rogers, Bob J.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.