Subject: Calculating the stress on the sun gear PSRU shaft.
From: Rotary Engine
Date: 6/20/2007, 7:23 PM
To: AARotary Engine


I am stuck on a design problem.  Do you happen to know the formula for
calculating torque strength of the drive pinion shaft that goes from the
transmission into the clutch?   In my case with the RX-4 intermediate
housing I have a 3/4" hardened steel shaft that goes into a torque
converter.   It is hard to imagine this shaft would be able to carry the
load essentially directly coupled to the engine flex plate on one end and
the PRSU on the other.


It is also baffling how people are putting 350 or more horsepower through
this shaft into the transmission.   I am assuming on the car the clutch
helps a lot whereas on an airplane the shaft would experience more stress
because of the huge prop flywheel. Assume minimal design load is 350hp and
220 ft. pound. and a four inch long shaft.  It would be very similar to what
Buly had to contend with a request for a longer than normal sun gear shaft
for Tracy's PSRU. mounted to his Cosmo auto tranny.


Thanks


Doug

http://physics.uwstout.edu/Statstr/statics/Torsion/tors51.htm#Topic%205.1:%20T
orsion:

max stress = T R/J

where T (inch pounds) is the internal torque in that section of the shaft,
R = maximum radius of the shaft(inches), and J = polar moment of inertia.

J = (Pi/32) d^4 for a solid shaft, and J = (Pi/32)(do^4 -di^4) for a
hollow shaft, where do = outer diameter and di = inner diameter. In inches.

Notice there is nothing about length.

Paul Lamar ...No rotor no motor.

Paul


WOW that was fast.  Great website.  Thanks.  I think I'll take the course
and clear the cobwebs:)

Example 1:
A solid steel shaft, shown in Diagram 1, has a 1 inch diameter and an
allowable shear stress of 12,000 lb/in2. What is the largest amount of power
which could safely be transmitted down the shaft if it is to rotate at 2400
rpm?



Solution:
Step 1: First, using the maximum allowable shear stress, we determine the
largest torque which may be applied to the shaft. The formula for the shear
stress in a shaft is:
= T r / J ; then solving for the torque: T = J / r ; where
J = (3.1416) d4 / 32 = .098 in4; r = .5 inch; and = 12.000 lb/in2, (We use
the allowable shear stress as the maximum stress in the shaft.) Putting
values into the equation and solving:
T = 12,000 lb/in2 * .098 in4 / .5 in = 2356 in-lb = 196 ft-lb.

Step 2: Now that we have the maximum torque we can safely apply, we can
determine the largest amount of power we can transmitted from the horsepower
equation.
Php = 2 pi T n/ 550 =   2 (3.1416) 196 ft-lb. (40 rev/s)/ (550 ft-lb/s/hp) =
90 hp

We don't know the alloy of the shaft of course.

This example is here.
OK http://physics.uwstout.edu/Statstr/statics/Torsion/torse53a.htm

------------------------------
For your viewing pleasure on 4340 pre made tough axles go to this website
and scroll down to Super 88 Jeep axles.  Look familiar:)

http://www.4wd.com/manufacturer-pages/Superior.aspx



Doug Fir



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.