I am stuck on a design problem. Do you happen to know the formula for
calculating torque strength of the drive pinion shaft that goes from the
transmission into the clutch? In my case with the RX-4 intermediate
housing I have a 3/4" hardened steel shaft that goes into a torque
converter. It is hard to imagine this shaft would be able to carry the
load essentially directly coupled to the engine flex plate on one end and
the PRSU on the other.
It is also baffling how people are putting 350 or more horsepower through
this shaft into the transmission. I am assuming on the car the clutch
helps a lot whereas on an airplane the shaft would experience more stress
because of the huge prop flywheel. Assume minimal design load is 350hp and
220 ft. pound. and a four inch long shaft. It would be very similar to what
Buly had to contend with a request for a longer than normal sun gear shaft
for Tracy's PSRU. mounted to his Cosmo auto tranny.
Thanks
Doug
http://physics.uwstout.edu/Statstr/statics/Torsion/tors51.htm#Topic%205.1:%20T
orsion:
max stress = T R/J
where T (inch pounds) is the internal torque in that section of the shaft,
R = maximum radius of the shaft(inches), and J = polar moment of inertia.
J = (Pi/32) d^4 for a solid shaft, and J = (Pi/32)(do^4 -di^4) for a
hollow shaft, where do = outer diameter and di = inner diameter. In inches.
Notice there is nothing about length.
Paul Lamar ...No rotor no motor.
Paul
Here is another better site for a possible source of custom high strength
PSRU sun gear shafts or even custom ordered output prop shafts.
http://www.marlincrawler.com/htm/axles.htm
Doug Fir
Those are too small Tracy uses a AA fuel dragster rear axle forging for the prop
shaft.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.