Subject: Extra bolt in 3rd gen and 20B rear housings
From: Rotary Engine
Date: 6/20/2007, 7:29 PM
To: AARotary Engine




> Anybody have the coordinates, position or dimensions
> for this bolt? Larry and Jarrett, we need to add provisions for this
> bolt. I think it is the same on the RX8 rotor motor.
> We could just beef up the whole flange in this area.
> > It will make Al happier too.
> > Paul Lamar ...No rotor no motor.

I don't have any info on it as of right now but if I do get or
find some I'd be glad to add it.

Jarrett

We could just put some meat about there and allow the builder to match drill
the 10 mm hole.

Paul Lamar

Yup.. Larry could also machine it off it the customer doesn't need/want it..

Any idea of a rough angular location?

Jarrett

Keep reading. I just uploaded what George said. Here it is again.

-- 
Paul,
I just had that BH in my hands last weekend, to check that very position.
The Polar Angle is approx 101.25 degrees and is on the same radius as the
majority of the BH mount holes, which is 182mm. Only the lower LHS is 180mm
This is the Cosmo End Housing.
George ( down under)

Thanks George.
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.