Subject: Mazda fuel low level warning probe
From: Rotary Engine
Date: 6/20/2007, 7:06 AM
To: AARotary Engine

        Gents,

        I'm using a stock Mazda fuel pump and assembly in my feeder
   tank. A
        fuel low
        level warning probe is part of the assembly holding the fuel pump.
        It's normally extended down to the bottom of the car's fuel tank.
        I've bent
        it up to give me an indication when the feeder tank is NOT full.
        The probe has one wire that comes out of it to the top plate of the
        assembly. I put my multimeter on the wire and on a ground (since I
        didn't
        know where else to put it and selected OHMs on various scales. I
        dipped the
        probe in and out of a can full of gas without any indications
   on the
        multimeter. If the probe is a switch, doesn't it need two wires?
        What makes
        this probe work?

        Thanks,
        Sandy McNabb
        Glass Goose with Rotor

        Good question. I have never ever seen one. If it is anything like
        the low
        oil level sensor it is a reed switch with a magnet float.
        http://en.wikipedia.org/wiki/Reed_switch
        <http://en.wikipedia.org/wiki/Reed_switch>
        One wire is grounded to the chassis.

        Sometimes the level sensors are pots on the end of a float arm.
        That will require two wires.

        Take some pictures.

        Here is the aircraft way of doing it.

        Paul Lamar ...No rotor no motor.


        If you are looking for a sensor that will indicate when your feeder
        tank is
        not full, you might want to consider the product shown at this web
        page:   http://www.aircraftextras.com/LowOilSensor.htm

        Although it is promoted as a low oil level sensor, it works equally
        well in
        fuel or water. The optional blinking LED setup is needed to have a
   panel
        warning system that comes on when the fluid level drops below the
        top of the
        float.

        Rogers, Bob J.

        Paul, Bob, et al,

        I've attached two pictures of the probe.

        Thanks for the web site for the oil level sensor. However, I need a
        sensor/probe that will attach to the top of the tank to sense lack
        of fuel
        at that location so I can be warned when the tank is NOT full.
   If I
        can't
        figure out the Mazda probe works, then I'm thinking about using a
   sensor
        normally used in house security systems that activates with a
        magnet. I'd
        have to evaluate how it would hold up in fuel. Other than that,
   it is
        completely sealed.

        Thanks, Sandy

        Could be a capacitance type.

        Paul Lamar

   Sandy,
   I used a the GEMS sensors.  It uses a prism lense that reflects when the
   prism is submerged and doesn't reflect when it isn't submerged.  I
   wanted it
   to tell me when fuel in the tank was low (7 gal.).  It works great
   and is
   simple to install.

   Mark St.

   Mark,

   That's perfect! And, they have several others that should work well
   also.
   Thanks for the tip.

   Sandy McNabb
   Glass Goose with Rotor


Sandy,
You can often find GEMS sensors on ebay for about $10/ea.  Retail they
go for about $100/ea.

Mark



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.