Subject: Calculating the stress on the sun gear PSRU shaft.
From: Rotary Engine
Date: 6/21/2007, 8:23 AM
To: AARotary Engine


I am stuck on a design problem.  Do you happen to know the formula for
calculating torque strength of the drive pinion shaft that goes from the
transmission into the clutch?   In my case with the RX-4 intermediate
housing I have a 3/4" hardened steel shaft that goes into a torque
converter.   It is hard to imagine this shaft would be able to carry the
load essentially directly coupled to the engine flex plate on one end and
the PRSU on the other.


It is also baffling how people are putting 350 or more horsepower through
this shaft into the transmission.   I am assuming on the car the clutch
helps a lot whereas on an airplane the shaft would experience more stress
because of the huge prop flywheel. Assume minimal design load is 350hp and
220 ft. pound. and a four inch long shaft.  It would be very similar to what
Buly had to contend with a request for a longer than normal sun gear shaft
for Tracy's PSRU. mounted to his Cosmo auto tranny.


Thanks


Doug


http://physics.uwstout.edu/Statstr/statics/Torsion/tors51.htm#Topic%205.1:%2
0>> T
orsion:

max stress = T R/J

where T (inch pounds) is the internal torque in that section of the shaft,
R = maximum radius of the shaft(inches), and J = polar moment of inertia.

J = (Pi/32) d^4 for a solid shaft, and J = (Pi/32)(do^4 -di^4) for a
hollow shaft, where do = outer diameter and di = inner diameter. In inches.

Notice there is nothing about length.

Paul Lamar ...No rotor no motor.


Paul

Here is another better site for a possible source of custom high strength
PSRU sun gear shafts or even custom ordered output prop shafts.

http://www.marlincrawler.com/htm/axles.htm

Doug Fir

Those are too small Tracy uses a AA fuel dragster rear axle forging for the
prop
shaft.

Paul Lamar ...No rotor no motor.

Paul,

Yes they are small for a prop shaft but perhaps they have the ability to
make a custom prop shaft.  I need something on order of 3" in OD. It will no
doubt become a thick pipe to cut down on weight.

I was thinking they may something in the 1 inch or 1.135" dia category for
the sun gear to engine connection.

Doug

Custom prop shaft/flange forgings are big bucks. Keep looking.
Someone some where may have one. Especially in the truck or heavy
equipment market.

The input shaft torsional has little to do with it as it is only
about 200 foot pounds and rather short. The gear, clutch plate and spline stiffness has
a lot more to do with the resonant condition at 1800 RPM. If you use Tracy's isolator
design with soft rubber bushings you can get it down below 1000 RPM.

The prop shaft must deal with up to 600 foot pound bending due to
gyro loads caused by rapid shifts in yaw and pitch. A stall would results in
a pitch rate of about one radian per second. That is 57 degrees per second.
(roughly Dave Mc :)) That is why you need a 2 inch or larger dia prop shaft.
It is not the torsion. It is the bending.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.