Here are a couple of pictures from the CD that Dave McCandless
mailed me from Western Australia thanks a bunch Dave.
Looks like the planetary PSRU was incorporated into the
aluminum end housing. Nice feature. The engine is plugs up
but that was a bad feature IMHO as it put the hot
part of the engine at the top where steam pockets
might occur. It is a p-port engine with real LONG
runners. Too long in fact :)
The cooling air flowed over the engine before entering
the rad. Not a good idea as every one degree increase in
cooling air temp is a 1% reduction in cooling.
The pdf is 3.7 meg too big to send by email.
Paul Lamar ...No rotor no motor.
Impressive. What's the date on the article? I'll bet my dad has a copy
of it (that I could mooch).
I'll bet Gordon likes the long runners... :)
Matt-
June 1989.
More pictures.
Paul Lamar ...No rotor no motor.
----------------------------------------------------------
More pictures from the May 91 article.
The runners are getting shorter :)
The dynamic balance is totally unnecessary on a two rotor engine.
Nobody has ever broken a shaft if it was properly balanced.
Paul Lamar ...No rotor no motor.
Paul,
That engine is quite a piece of work.
Curious indeed about those dampers. They look like puck dampers that
were used on some early big radials -- see attached.
With that wood prop one would think Everett need not be that concerned
about torsional damping. Perhaps he was anticipating heavier CS props?
Regards,
Gordon.
PS: That snippet about puck dampers is part of a great article -- short
book really -- on the development of the R2800. It can be downloaded here:
http://www.enginehistory.org/engines.htm
scroll down to "No short days..."
They look just like the dampers in my O-470.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.