The engine is plugs up but that was a bad feature IMHO as it put the hot
part of the engine at the top where steam pockets
might occur.
It is a p-port engine with real LONG runners.
The cooling air flowed over the engine before entering
the rad. Not a good idea as every one degree increase in
cooling air temp is a 1% reduction in cooling.
Paul Lamar ...No rotor no motor.
Hi Paul and Rotorheads,
I think I have become a Pport exponent. I wonder who did the al castings of the end
housings for Everett's engine, and what happened to the patterns?
***** What I like about plugs up is that the exhaust goes straight out the bottom of the cowl,
and leaves plenty of room for the induction runners as shown. Any fuel leaks can be easily kept
away from the hot pipe. Those steam pockets could be a worry, though they did not
seem to worry Everett :)
***** I was tempted to say the inbound air is also cooling the motor, but I guess 90% of
this heat is from the exhaust header; yeah, hit the rad with the coolest air possible.
With all our insight and comments, we still have a long way to go to catch up on
Everett's research and knowledge.
What a loss.
BR, Dave McC
The other problem with plugs up is oil drain back. However if you are designing
your own end housings that can be fixed.
The thing about air flowing over the engine and exhaust first is; the hotter the air
flowing over the engine the worse the cooling...the worse the cooling the hotter the
engine and the hotter the air flowing over it. This is known as positive feedback.
In this case it is a negative result.
BTW Positive feed back can lead to run away situations like melt down and nuclear explosions :)
The same sort of thing can happen inside the engine when you get a steam pocket. The metal
gets hotter in that area so the steam pockets gets larger so the metal gets hotter
yet. A fundamental problem with liquid cooling.
In the rotary there are a lot of small pockets around the spark plugs bosses that are
not directly connected to each other due to the tension bolt bosses so steam pockets
can start easily with no good way to vent the steam.
The picture shows a Mazda sand cast p-port rotor housing with communication slots
milled into the rotor housing to vent the areas prone to steam pockets (At least I think
this is what they are for.). It took awhile for the content of this picture to dawn on me.
At first I had no idea why the slots were there. I intend to make this mod on
the RX8 p-port engine I am building.
In an air cooled engine as the metal gets hotter the rate of cooling increases as
the cooling is proportional to the difference in temperature between metal and air.
This is negative feed back with positive results.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.